Services

Engine Diagnostics

A set of tests using an engine scan computer will locate the source of poor engine performance or running problems. The vehicle’s sensors, fuel pressure and emission systems are all checked by a highly trained Technician.

Tune-ups

A necessary part of vehicle maintenance wherein the spark plugs, air filter, and fuel filter are replaced.

Electrical Work

Tracing and locating shorts in the vehicle’s electrical system, which includes window motors, door locks, taillights, headlights, and instrument clusters. Due to the complexity of a vehicle’s electrical system, this work is best left to one of our highly trained technicians.

Fuel Injection

We monitor, maintain, or replace the components of a fuel injection system to keep the vehicle running at optimum performance reducing green house gas emissions and protecting the environment.

Timing Belts

We recommend replacing timing belts as a part of a standard maintenance program. Failure to do so can cause sudden catastrophic engine damage.

Batteries/Charging Systems

The battery is tested for load capacity and the alternator is tested for amp/voltage output to sustain the charge of the battery.

Air Conditioning 134A and 1234YF

The air conditioning system is checked for leaks, Refrigerant level, and blower volume. Parts are replaced as necessary. When a leak is not detectable upon initial inspection, a dye is used to pinpoint the location. Parts are required to be replaced as necessary due to refrigerants ability to harm the ozone.

Clutches/Flywheels

Requires removal of a vehicle’s transmission to replace a three part clutch assembly that includes pressure plate, disc, and throw-out bearing. The flywheel must also be machined. This is a very time-consuming repair.

Wheel Alignment/Front End

Using our computerized alignment machine, the technician adjusts and corrects wheel angles to provide minimum tire wear and secure handling.

Shocks/Struts/CV Joints

The shocks and struts control the ride of a vehicle and keep the wheels in contact with the road. Neither shocks nor struts can be repaired and the entire unit must be replaced. The boot covering the CV joint must be inspected for tears or breaks by a trained technician. This will prevent future damage from loss of lubrication and water or debris entering the precision machined components of the axle joint.

Brakes

All brake repairs begin with a thorough inspection to determine which parts or components need replacement or maintenance. Brake fluid is checked at the time of each oil change.

Cooling Systems/Radiators

One of our technicians checks the engine cooling system for proper antifreeze/coolant level, leaks, acid level and proper flow. In order for the cooling system to operate properly, belts, hoses, radiator, water pump and cooling fan/s must be in good condition and there should be no restrictions.

Lube, Oil Change and Filter Change

We recommend changing engine oil and filter according to your owner’s manual. While performing an oil change, our technicians check all fluids and perform a mini maintenance inspection. Most new vehicles do not require greasing, as moving parts are lubricated and sealed at the factory.

Electric Windows/Door Locks

Our highly trained electrical specialists are able to trace and locate shorts, in order to replace defective parts as necessary.

Tires/Sales and Service

Our experts help select proper tires based on individual use and vehicle requirements. When necessary to correct handling problems, we use our state of the art alignment equipment for alignments and balancing provide the most accurate tire balance possible.

Reprogramming/Flash

Today’s vehicles have many computers and these sometimes require reprogramming as recommended by the manufacturer. In addition, reprogramming the car’s computer can be a repair or part of a repair.